Green and red cables switched on lighting strip vs controller (solved)


#1

Hey Guys,

I just bought a Blinkstick Pro plus the LED adapter to control a lighting strip behind my monitor.
Unfortunately, the arrangement of the contacts on the Blinkstick Pro is [power, R, G, B] and the arrangement on the strip is [power, G, R, B]. So if i change the red value in software it affects the green LEDs and the other way round.
Is there any way of changing the arrangement on the software side of am I better off just soldering the wires the other way?
(I’m on 2.0 rc9)


#2

You can change the wires at the RGB out ports of the led adapter. This is the best way imo.


#3

Good call, thanks! That seems extremely obvious in retrospect now