# Green and red cables switched on lighting strip vs controller (solved) **URL:** \ **Category:** Support\ **Created:** [October 21, 2017, 1:36pm UTC](https://forums.blinkstick.com/t/green-and-red-cables-switched-on-lighting-strip-vs-controller-solved/825 "2017-10-21T13:36:57Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![r08chuet](https://forums.blinkstick.com/letter_avatar_proxy/v4/letter/r/ecae2f/32.png) [@r08chuet](https://forums.blinkstick.com/u/r08chuet)\ **Post date:** [October 21, 2017, 1:36pm UTC](https://forums.blinkstick.com/t/green-and-red-cables-switched-on-lighting-strip-vs-controller-solved/825/1 "2017-10-21T13:36:57Z")
Hey Guys, I just bought a Blinkstick Pro plus the LED adapter to control a lighting strip behind my monitor. Unfortunately, the arrangement of the contacts on the Blinkstick Pro is [power, R, G, B] and the arrangement on the strip is [power, G, R, B]. So if i change the red value in software it affects the green LEDs and the other way round. Is there any way of changing the arrangement on the software side of am I better off just soldering the wires the other way? (I’m on 2.0 rc9) ---
**Author:** ![p0ke](https://forums.blinkstick.com/user_avatar/forums.blinkstick.com/p0ke/32/14_2.png) [@p0ke](https://forums.blinkstick.com/u/p0ke)\ **Post date:** [October 21, 2017, 8:14pm UTC](https://forums.blinkstick.com/t/green-and-red-cables-switched-on-lighting-strip-vs-controller-solved/825/2 "2017-10-21T20:14:55Z")
You can change the wires at the RGB out ports of the led adapter. This is the best way imo. ---
**Author:** ![r08chuet](https://forums.blinkstick.com/letter_avatar_proxy/v4/letter/r/ecae2f/32.png) [@r08chuet](https://forums.blinkstick.com/u/r08chuet)\ **Post date:** [October 22, 2017, 2:15pm UTC](https://forums.blinkstick.com/t/green-and-red-cables-switched-on-lighting-strip-vs-controller-solved/825/3 "2017-10-22T14:15:52Z")
Good call, thanks! That seems extremely obvious in retrospect now